Spanning-Tree Portfast - Cisco SPS2024 Reference Manual

Cisco systems ethernet switch reference guide
Hide thumbs Also See for SPS2024:
Table of Contents

Advertisement

Spanning Tree Commands

spanning-tree portfast

spanning-tree portfast
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
Example
The following example configures the spanning priority on Ethernet port e15 to 96.
Console(config)# interface ethernet e15
Console(config-if)# spanning-tree port-priority 96
The spanning-tree portfast Interface Configuration mode command enables
PortFast mode. In PortFast mode, the interface is immediately put into the
forwarding state upon linkup without waiting for the standard forward time delay.
Use the no form of this command to disable PortFast mode.
Syntax
spanning-tree portfast [auto]
no spanning-tree portfast
Parameters
auto — Specifies that the software waits for 3 seconds (With no BPDUs
received on the interface) before putting the interface into the PortFast
mode.
Default Configuration
PortFast mode is enabled.
Command Modes
Interface Configuration (Ethernet, port-channel) mode
28
374

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sps224g4Sps208g

Table of Contents