Flowcontrol - Cisco SPS2024 Reference Manual

Ethernet Configuration Commands

flowcontrol

flowcontrol
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
Command Mode
EXEC
The flowcontrol Interface Configuration (Ethernet, port-channel) mode command
configures flow control on a given interface. Use the no form of this command to
disable flow control.
Syntax
flowcontrol {auto | on | off | rx | tx }
no flowcontrol
Parameters
•
auto — Indicates auto-negotiation
•
on — Enables flow control
•
off — Disables flow control
•
rx — Enables receiving pause frames only
•
tx — Enables transmitting pause frames only
Default Configuration
Flow control is off.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
Negotiation should be enabled for flow control auto.
12
159