Gvrp Enable (Interface) - Cisco SPS2024 Reference Manual

GVRP Commands

gvrp enable (Interface)

gvrp enable (Interface)
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
Example
The following example enables GVRP globally on the device.
Console(config)# gvrp enable
The gvrp enable Interface Configuration (Ethernet, port-channel) mode command
enables GVRP on an interface. Use the no form of this command to disable GVRP
on an interface.
Syntax
gvrp enable
no gvrp enable
Default Configuration
GVRP is disabled on all interfaces.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
An access port does not dynamically join a VLAN because it is always a member
in only one VLAN.
Membership in an untagged VLAN is propagated in the same way as in a tagged
VLAN. That is, the PVID is manually defined as the untagged VLAN VID.
13
183