Enable Password - Cisco SPS2024 Reference Manual

AAA Commands

enable password

enable password
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
The enable password Global Configuration mode command sets a local
password to control access to user and privilege levels. To remove the password
requirement, use the no form of this command.
Syntax
enable password [level
no enable password [level
Parameters
•
password —
Password for this level. (Range: 1-159 characters)
•
level —
Level for which the password applies. If not specified the level is 15
(Range: 1-15).
•
encrypted — Encrypted password entered, copied from another device
configuration.
Default Configuration
No enable password is defined.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets a local level 15 password called 'secret' to control
access to user and privilege levels.
Console(config)# enable password secret level 15
level password
] encrypted]
level]
2
44