Perform Clock Synchronization With Ntp Server - Cisco NCS 6008 Series Manual

Perform Clock Synchronization with NTP Server

Example:
RP/0/RP0/CPU0:router(config)#hw-module location 0/1/CPU0 slice 3 shutdown
Shuts down the specified slice. The interfaces belonging to the slice that is shut down are deleted from the system and
are not visible in the output of the show interfaces brief command.
Step 3 commit
What to do next
To make a shutdown slice operational, use the no hw-module location rack/slot/CPU slice slice_number
shutdown command.
Verify the slice shut down using show platform in XR VM or show platform slices in System Admin VM.
Perform Clock Synchronization with NTP Server
There are independent system clocks for the XR VM and the System Admin VM. To ensure that these clocks
do not deviate from true time, they need to be synchronized with the clock of a NTP server. In this task you
will configure a NTP server for the XR VM. After the XR VM clock is synchronized, the System Admin VM
clock will automatically synchronize with the XR VM clock.
Before you begin
Configure and connect to the XR VM management port.
SUMMARY STEPS
1. configure
2. ntp server server_address
3. commit
4. exit
5. sh run ntp
DETAILED STEPS
Step 1
configure
Step 2 ntp server server_address
Example:
The XR VM clock is configured to be synchronized with the specified sever.
RP/0/RP0/CPU0:router#ntp server 64.90.182.55
The System Admin VM clock is configured to be synchronized with the specified sever.
sysadmin-vm:0_RP0#ntp server 64.90.182.55
Step 3
commit
Step 4 exit
Bring-up the Cisco NCS 6008 Router
10
Bring-up the Cisco NCS 6008 Router