Joystick - Barco FSN Series User Manual

3. Control Panel Orientation
Control Panel Descriptions
FINE
ADJUST
CLEAR
TRIM -
TRIM +
1
+ / -
.
84
~
Press FINE ADJUST to change the sensitivity of the knobs and the

Joystick.

• When off, adjustment is coarse.
• When on, adjustment is fine.
~
Press CLEAR during a numeric entry process to clear the entire register.
A dash (–) appears in the register, but the selected mode (store or recall)
and all selected modules remain lit.
Press and hold CLEAR to cancel the current store or recall function
completely. The STORE or RECALL button automatically turns off.
~
Enter an offset value using the numeric buttons, then press TRIM - to
subtract from the parameter's current value. For example, if a
parameter's value is 100, press 10, TRIM -, to calculate 90. Pressing
ENTER is not required, and the "trim" value remains in the register,
enabling you to trim repeatedly by the same offset.
In Chapter 5, see the
Note The TRIM - function is only applicable when a Touch Screen
Keypad is active. It does not apply to memory registers.
~
Enter an offset value using the numeric buttons, then press TRIM + to
add to the parameter's current value. For example, if a parameter's
value is 100, press 10, TRIM +, to calculate 110. Pressing ENTER is not
required, and the "trim" value remains in the register, enabling you to trim
repeatedly by the same offset. In Chapter 5, refer to the
Keypad" section on page 130 for additional details.
Note
The TRIM + function is only applicable when a Touch Screen
Keypad is active. It does not apply to memory registers.
~
Press the numeric buttons 0 through 9 to enter numbers for memory
registers and other functions in the normal manner. Numbers shift left in
the register as you enter them.
~
Press +/- to invert the numeric entry in the register. For example, to
change the entry from + 350 to - 350, press +/-.
Note The +/- button is only applicable when certain Touch Screen
keypad functions that accept negative values are active. The
+/- button does not apply to memory registers.
~
Press the decimal button (.) as required for numeric entries that accept
decimal values.
Note The decimal button is only applicable when certain Touch
Screen keypad functions that accept decimal values are
active. The button does not apply to memory registers.
"Using the Keypad" section for details.
FSN Series • User's Guide
"Using the