Barco FSN Series User Manual page 253

8.
Use the following steps to set up native input color correction:
9.
10. To adjust the selected input's overall brightness and contrast, press {Brightness
11. To adjust the input's RGB brightness, press {RGB Brightness} . Use the {Red
12. To adjust the input's RGB contrast, press {RGB Contrast} . Use the {Red
13. To adjust hue and color saturation, press {Hue Sat} and adjust as desired.
Use the following steps to set up native input sync:
14. Press {Sync Mode} to set the input's synchronization mode. In the pop-up, select
15. Press {Refresh Sync} to refresh sync for the selected input only. This function is
Use the following steps to set up native input mask:
16. Press {Mask} to mask one or more edges of the video signal, if required. Use the
17. If required, press {Clear Mask} to clear all four masks to their default settings.
Use the following steps to save input settings:
18. Press {Save Settings} to save the selected input's setup parameters.
19. Press {Back} to return to the Input Menu .
20. Repeat from step 3 for each additional input that you wish to set up.
FSN Series • User's Guide
After a factory reset, the Sync Mode for all native inputs is set to Auto Sync . In
this mode, the system automatically determines whether to set Auto: Minimum
Delay mode or Auto: Frame Sync mode for each input. If Auto: Frame Sync is
set, the system will not return to Auto: Minimum Delay mode until the sync
processing is refreshed for the input.
To refresh sync for all inputs, press {Refresh All Sync} . Next, in the pop-up,
press {Yes} . Native inputs set to Frame Sync or Minimum Delay modes will not
be affected. Only inputs set to Auto: Frame Sync mode will be affected.
Note If you want to refresh sync for just a selected native input, use
the {Refresh Sync} button on the Input Setup Menu .
Note This function does not apply to universal inputs.
Press {Setup} to display the Input Setup Menu for the selected native input.
Contrast} . Use the {Brightness} and {Contrast} controls as desired.
Brightness} , {Green Brightness} and {Blue Brightness} controls as desired.
Contrast} , {Green Contrast} and {Blue Contrast} controls as desired.
{Auto} , {Minimum Delay} or {Frame Sync} mode. In Chapter 5, refer to the
" Sync Section " heading for a complete discussion of each sync mode.
only required in Auto Sync mode. If the system switches from Auto: Minimum
Delay to Auto: Frame Sync , the system will not return to Auto: Minimum Delay
until the sync processing is refreshed.
{Mask Top} , {Mask Bottom} , {Mask Left} and {Mask Right} controls as
required. When a mask is applied on an edge, black is revealed.
Important Because you can install either a NIC or a UIC in slots 3 and 4 ,
If you move or change card assignments in these two slots
during setup, the setup is invalidated, and must be repeated
once the final card configuration is reached.
6. System Setup
Native Input Setup
253