Table of Contents
Advertisement
3. Control Panel Orientation
Control Panel Descriptions
BG
KEY
1
KEY
2
74
Following are descriptions of each button in the Next Transition Group:
~
Enable BG to "arm" the background layer for a transition.
•
When BG is enabled, the selected PST source appears in the
M/E's preview monitor output.
•
When BG is not enabled, the selected BG source appears in
the M/E preview monitor output.
When the transition is performed, the PST source flips to BG.
If BG is off, the current BG source is held during the next transition —
even if a different source is selected.
~
Enable KEY 1 to "arm" a transition to or from the KEY 1 layer, using the
source selected on the Key Bus. The red LED above the button lights
when the key is on.
•
If KEY 1 is currently off and you enable it, the next transition
turns the key on. The key source appears in the M/E's preview
output.
•
If KEY 1 is currently on and you enable it, the next transition
turns the key off. Here, even though the key is on, the key is
removed from preview — showing the M/E's next look.
•
Press and hold KEY 1 to display the Key Menu, with Key 1
highlighted.
If the KEY 1 button is off, Key 1 will not transition. If the key is currently
off, it stays off. If the key is currently on, it holds.
~
Enable KEY 2 to "arm" a transition to or from the KEY 2 layer, using the
source selected on the Key Bus. The red LED above the button lights
when the key is on.
•
If KEY 2 is currently off and you enable it, the next transition
turns the key on. The key source appears in the preview
output.
•
If KEY 2 is currently on and you enable it, the next transition
turns the key off. Even though the key is on, the key is removed
from preview — indicating the M/E's next look.
•
Press and hold KEY 2 to display the Key Menu, with Key 2
highlighted.
If the KEY 2 button is off, Key 2 will not transition. If the key is currently
off, it stays off. If the key is currently on, it holds.
Note
The Key Menu can be used at any time to adjust key
parameters, whether or not the key is on. In Chapter 5, refer
to the
"Keyer
The following rules apply to all three buttons in the Next Transition Group:
~
As you enable or disable buttons in the group, the selected layer appears
(or is removed) on the M/E's Preview output.
~
At the end of a transition (either manual or automatic), all buttons that
you enabled in the group remain on. This allows you to transition back to
the previous configuration.
Menu" section on page 143 for details.
FSN Series • User's Guide
Advertisement
Table of Contents
