Barco FSN Series User Manual page 113

k~íáîÉ=fåéìí=`çååÉÅíáçåë
The figure below illustrates native input connections on a NIC's I/O panel:
SDI Input 1
SDI Input 2
SDI Input 3
SDI Input 4
SDI Input 5
SDI Input 6
SDI Input 7
SDI Input 8
Figure 4-18. Native input connections
Use the following steps to connect native inputs to a NIC.
1.
Please note the following important points:
•
•
•
FSN Series • User's Guide
SDI
1
2
3
4
5
6
7
8
Note All connections use BNC cables.
Connect SD-SDI or HD-SDI input signals to the NIC's SDI inputs 1 through 8. All
signals must match the system's native resolution, as set on the Output Setup
Menu. In Chapter 6, refer to the
on page 248 for instructions on setting the native resolution.
Use the Input Setup Menu to set up native SDI input signals. In Chapter 5, refer
to the "Input Menu" section on page 187 for menu details.
In Chapter 6, refer to the "Native Input
step setup instructions.
If you want to connect an input to the FSN-1400 whose resolution is different that
the system's native output resolution, use a UIC. Refer to the
Connections" section on page 114 for details.
"Reference Video and Output
Setup" section on page 252 for step-by-
4. Installation
Signal Connections
Setup" section
"Universal Input
113