Barco FSN Series User Manual page 185

Two mutually exclusive points are provided for the PGM bank's clean feed output.
•
•
^ëëáÖå=_ìííçå
Press {Assign Button} to select the clean feed source that is mapped to the ASSIGN
button in the control panel's Aux Section . This feature enables you to place a clean feed
Assign
source on the Aux Source Row , and select it (just as you would any other available
Button
source), and send it to an Aux bus destination.
When {Assign Button} is pressed, the Palette changes to display a different "flow-chart."
This diagram represents the clean feed points that can be mapped to the ASSIGN button,
with buttons provided for each selection point.
Figure 5-79. Clean Feed Setup Menu, Assign Button selection (sample)
One of three mutually exclusive clean feed points can be mapped to the ASSIGN button:
•
•
FSN Series • User's Guide
Press {PGM Clean} to select the clean feed point prior to the DSK.
Press {PGM Out} to select the program output (after the DSK).
Note The M/E 2 clean feed connection points are not available in
release 1.0.
Press {M/E 1 Clean 1} to select the clean feed point prior to Keyer 1.
Press {M/E 1 Clean 2} to select the clean feed point prior to Keyer 2.
5. Menu Orientation
System Menu
185