Barco FSN Series User Manual page 247

Table of Contents

Advertisement

`çããìåáÅ~íáçåë=pÉíìé
FSN Series system setup: Step 5
In this procedure, you will set up communication between the FSN-1400 and the control
5
panel.
Use the following steps to set up communications:
1.
2.
3.
4.
5.
6.
7.
FSN Series • User's Guide
Prerequisite — Ensure that you are familiar with the Communications
Setup Menu . In Chapter 5, refer to the "
section on page 175.
In the Menu Bar , press {System} to access the System Menu .
Important
If communication is not properly set up, numerous buttons will
be grayed out on the System Menu . These buttons will
activate once communication is properly set.
Press {Com Setup} to display the Communications Setup Menu .
Review the data in the Ethernet Status Table , and ensure the following:
~
FSN-150 Ethernet 1: Connected
~
FSN-1400 Ethernet: Connected
If status is " Connected ," communication is properly set up. Please continue with
the "
Reference Video and Output Setup
If status is " Not Connected ," press {Discover FSN-1400} to locate the IP
address(es) of all FSN-1400 units within your local network.
~
If the pop-up alerts you that no FSN-1400 units have been discovered,
check all Ethernet connections, then press {Discover FSN-1400} again
to re-try the procedure.
~
If FSN-1400 units are discovered, the FSN-1400 Selection Keypad
appears. Select the desired FSN-1400 , and press {Connect} .
(Advanced)
If you need to change the IP address of a highlighted port, for
example, if your system is connected to a house network, press {Set IP Address}
to display the IP Address Keypad . Enter the desired address and press {Enter} .
(Advanced)
If you need to change the subnet mask of a highlighted port, press
{Set Subnet Mask} to display the Subnet Mask Keypad . Enter the desired
subnet mask and press {Enter} .
(Advanced)
If you need to return a highlighted port's IP address and Subnet
Mask to their factory default values, press {Return to Default} .
6. System Setup
Communications Setup
Communications Setup Menu
" procedure on page 248.
"
247

Advertisement

Table of Contents
loading

Table of Contents