Barco FSN Series User Manual page 257

bñíÉêå~ä=aph=fåéìí=pÉíìé
FSN Series system setup: Step 11
In this procedure, you will set up the external DSK inputs.
11
Use the following steps to enable or disable external DSK error reporting:
1.
2.
3.
Use the following steps to set up external DSK input color correction:
4.
5.
6.
7.
8.
Use the following steps to save DSK input settings:
9.
10. Press {Back} to return to the System Menu .
FSN Series • User's Guide
Prerequisite — Ensure that you are familiar with the following menus:
~
External DSK Setup Menu — Chapter 5, "
page 208.
~
Connector Colors — Chapter 5, "
In the Menu Bar , press {System} to access the System Menu .
Press {External DSK Setup} to display the External DSK Setup Menu .
Enable or disable error reporting for the DSK inputs, as required. In the Rear I/O
View , press each DSK input connector, then press {Error Reporting} . The
table's Error Reporting column indicates if error reporting is on or off.
~
If you elect not to use the external DSK inputs, turn error reporting off. to
prevent error messages.
~
If you elect to use the inputs, ensure that your inputs are properly
connected to the external DSK Cut and DSK Fill connectors.
Note Remember that the DSK Cut input can not be adjusted.
In the Rear I/O View , press the DSK Fill connector.
To adjust the input's overall brightness and contrast, press {Brightness
Contrast} . Use the {Brightness} and {Contrast} controls as desired.
To adjust the input's RGB brightness, press {RGB Brightness} . Use the {Red
Brightness} , {Green Brightness} and {Blue Brightness} controls as desired.
To adjust the input's RGB contrast, press {RGB Contrast} . Use the {Red
Contrast} , {Green Contrast} and {Blue Contrast} controls as desired.
To adjust hue and saturation, press {Hue Sat} . Use the {Hue} and {Sat} controls
as desired.
Press {Save Settings} to save the DSK Fill input's setup parameters.
6. System Setup
External DSK Input Setup
External DSK Setup Menu
Connector Colors ," page 189.
,"
257