Barco FSN Series User Manual page 114

4. Installation
Signal Connections
råáîÉêë~ä=fåéìí=`çååÉÅíáçåë
The figure below illustrates universal input connections on a UIC's I/O panel:
Universal Input 1, Analog
Universal Input 1, SDI
Universal Input 2, SDI
Universal Input 2, Analog
Figure 4-19. Universal input connections
Use the following steps to connect universal inputs to a UIC.
1.
2.
3.
4.
5.
6.
Please note the following important points:
•
114
Universal Input 1
Digital only
Universal Input 2
Digital only
Using an HD-15 cable directly, or an HD-15 to 5 x BNC breakout cable, connect
the desired analog input to the Universal Input 1, Analog connector.
Using a standard DVI cable, connect the desired digital input to the Universal
Input 1, Digital connector. The connector accepts digital signals only.
Using a BNC cable, connect the desired SDI signal to the Universal Input 1, SDI
connector.
Using an HD-15 cable directly, or an HD-15 to 5 x BNC breakout cable, connect
the desired analog input to the Universal Input 2, Analog connector.
Using a standard DVI cable, connect the desired digital input to the Universal
Input 2, Digital connector. The connector accepts digital signals only.
Using a BNC cable, connect the desired SDI signal to the Universal Input 2, SDI
connector.
You can connect three signals to UIC Input 1, and three signals to UIC Input 2,
but you can only use one signal at a time for each input. However, you can also
store setup files for different input combinations, and recall the desired setup to
1
2
FSN Series • User's Guide