Barco FSN Series User Manual page 300

7. Operations
Using Custom Control Functions
4.
rëáåÖ=`ìëíçã=`çåíêçä=cìåÅíáçåë
The Custom Control Section provides groups of buttons that can be programmed to
perform various switcher functions.
Use the following steps to use Custom Control functions:
1.
2.
3.
4.
5.
300
To set the ASSIGN button source:
~
Press {Assign Button} . The Palette changes to the Assign Button
flowchart.
~
Select the desired clean feed point for the ASSIGN button.
Note Remember that only one clean feed source can be mapped to
the ASSIGN button for all Aux buses. For example, you
cannot map " Pre KEY 1 " to Aux 1, and " Pre KEY 2 " to Aux 2.
Prerequisites — Ensure that you are familiar with the Custom Control
Section . In Chapter 3, refer to the "
page 80 for details.
Note In release 1.0, only pre-programmed "system" functions such
as ALL TRAN , FRZ , UNFRZ , etc., are available.
To freeze a source:
~
Press and hold FRZ , then press the desired source button (on any bus).
Note that this is the same as toggling the {Freeze} button to " On " — on
the Input Menu .
To un-freeze a source:
~
Press and hold UNFRZ , then press the button for the frozen source (on
any bus). Note that this is the same as toggling the {Freeze} button to
" Off " — on the Input Menu .
To perform an auto transition on all banks simultaneously:
~
Press ALL TRAN . All banks will transition, each at their own selected
transition rate.
To perform a on all banks simultaneously:
~
Press ALL CUT . All banks will cut immediately.
To save all system settings:
~
Press SAVE ALL . All parameters under the System Menu will be saved
to non-volatile memory. Note that this function is the same as pressing
{Save All} on the System Menu . In Chapter 5, refer to the "
section on page 220 for a list of the functions that are saved.
Custom Control Section
FSN Series • User's Guide
" heading on
Save All "