Barco FSN Series User Manual page 144

5. Menu Orientation
Keyer Menu
hÉóÉê=jÉåì=^ÅÅÉëë
There are two ways to access the Keyer Menu :
•
•
hÉóÉê=pí~íìë=q~ÄäÉ
A Key Status Table is displayed at the top of the Palette , as shown below:
Keyer
M/E 1, Key 1
M/E 1, Key 2
DSK
Figure 5-39. Key Status Table (sample)
In the table, rows are provided for each keyer on the panel, and the yellow highlight shows
the active keyer. This highlight changes automatically when different keyers are selected.
The following columns of information are provided:
•
•
•
•
144
In the Menu Bar , press {Page} to display page 1 (if required). Then, press the
{Keys} button. The parameters for the last selected or modified keyer are
displayed.
Arm the desired keyer first, then press and hold that Keyer button (e.g., KEY 1 or
KEY 2 in the M/E 1 bank, or the DSK button in the PGM bank). The parameters
for that specific keyer are displayed, and the location is named in the Title Bar
(e.g., Keyer Menu: M/E 1, Key 1 ).
Cut Type
CAM1 Luma
CG Linear
PC3 Luma
Keyer — Indicates the name of each keyer on the panel.
Cut — Indicates the key's cut source, as selected on the bank's Key Bus .
Type — Indicates the key type, either Luma or Linear , as selected with the
{Type} button. Refer to the "
Fill — Indicates the key's fill source, either Self , Split , Matte or PST (Preset Bus),
as selected with the {Key Fill} button. If the key is split, the name of the split fill
source appears in the cell. Refer to the "
Fill
Self
CG
Self
Type " section on page 146 for details.
Key Fill " section on page 148 for details.
FSN Series • User's Guide