Barco FSN Series User Manual page 244

6. System Setup
Power Up and Status Check
mçïÉê=ré=~åÇ=pí~íìë=`ÜÉÅâ
FSN Series system setup: Step 1 .
Use the following steps to power up your system and check system status.
1
1.
2.
3.
4.
244
Prerequisite — Ensure that your system is properly installed and cabled. In
Chapter 4, refer to the following sections for details:
~
" Control Panel Installation
~
" Touch Screen Installation
~
" FSN-1400 System Connections
Prerequisite — Ensure that you are familiar with the System Menu . In
Chapter 5, refer to the "
complete details.
Power up the FSN-1400.
Power up the FSN-150 control panel. The System Menu is automatically
displayed after boot up.
Important If communication is not properly set up, numerous buttons will
be grayed out on the System Menu . These buttons will
activate once communication is properly set.
Power up all additional peripherals, such as monitors and sources.
On the System Menu :
~
In the System Status Table , ensure that all devices are connected. If
not, re-check all Ethernet connections. After checking connections, if
devices still report " Not Connected ," use the "
procedure on page 247.
~
Ensure that the software versions for the control panel and FSN-1400
match. If not, you may need to update control panel software or match
the FSN-1400's software to the installed control panel software. Refer
to Chapter 8, " Updating Software
Note If the software versions on the control panel and FSN-1400
match, you do not need to upgrade.
~
In the FSN-1400 Status Table , ensure that all installed NIC and UIC
cards are recognized. If not, you may need to re-seat the boards.
," page 94.
," page 95.
," page 100.
System Menu Description
" on page 301 for details.
FSN Series • User's Guide
" section on page 170 for
Communications Setup "