Table of Contents
Advertisement
2)
3)
4)
5)
6)
7)
8)
FSN Series • User's Guide
•
DC output from one (of the two) chassis power supplies is bad
or has failed.
•
Power is bad (or has failed) on one or more of the installed
circuit cards.
~
Off = one or more of the following conditions are present:
•
The chassis is turned off.
•
DC output from all power supplies is bad or has failed.
•
Power has failed on the System Card.
Note that this LED is carried through to the front door via light pipe.
Video Reference LED
The Video Reference LED indicates the status of the system's analog video
reference input, via the Vid Ref connector on the System Card's rear I/O card.
~
Green
= the system is configured for External Reference, a video
reference signal is present and the FSN-1400 is locked to the signal.
~
Red
= the system is configured for External Reference, the signal is
missing or the FSN-1400 is not locked to the signal.
~
Off = the system is configured for Free Run.
Note
If the Power LED is off, the Video Reference LED will also
be off.
Note that this LED is carried through to the front door via light pipe.
Ejectors
Use the card's top and bottom Ejectors to remove (and re-insert) the card.
Card Power LED
The Card Power LED indicates power status for the card. Refer to the
LEDs" section on page 55 for details.
Loaded LED
The Loaded LED indicates the status of all FPGAs on the card. Refer to the
"Card
LEDs" section on page 55 for details.
Diagnostic Port
One RS-232 port is provided for diagnostics. This port is not available to the user.
CPU Reset Switch
Using a small tool such as a paper clip, press the CPU Reset Switch to perform a
soft system reset. This function reboots the system, but preserves all setups and
memory registers, and maintains all crosspoint selections on the control panel.
Please note:
~
This is the same as pressing {Soft Reset System} on the Reset Menu.
In Chapter 5, refer to the
IP Address Reset Switch
Using a small tool such as a paper clip, press the IP Address Reset Switch for 5
(five) seconds. This action resets the chassis IP address to the default value of
192.168.0.4, and then performs a factory reset. Please note:
~
This is the same as pressing {Factory Reset} on the Reset Menu. In
Chapter 5, refer to the
2. FSN-1400 Orientation
"Reset
Menu" section on page 235 for details.
"Reset
Menu" section on page 235 for details.
Card Descriptions
"Card
39
Advertisement
Table of Contents
