Barco FSN Series User Manual page 111

^ìñ=lìíéìí=`çååÉÅíáçåë
Aux (auxiliary) buses are extra switching buses that allow video signals to be routed from
the FSN-1400 to external equipment such as VTRs, monitors, projectors, etc. The figure
below illustrates the Aux output connections on the M/E card's I/O panel:
PVW
CLN
PGM
PVW
CLN
PGM
PVW
CLN
Figure 4-16. Aux output connections
Use the following steps to connect Aux output signals from the FSN-1400's M/E card.
1.
Please note the following important points:
•
FSN Series • User's Guide
PGM
Cut
Fill
Aux Out 1
1
Aux Out 2
2
Aux Out 3
3
Aux Out 4
4
Aux Out 5
5
Aux Out 6
6
Note All connections use BNC cables.
Connect Aux Outputs 1 through 6 to your target auxiliary devices or monitors.
All Aux outputs run at the system's selected native output resolution. In
Chapter 6, refer to the "Reference Video and Output
page 248 for instructions on setting the native resolution.
4. Installation
Signal Connections
Setup" section on
111