Barco FSN Series User Manual page 294

7. Operations
Working with Memory Registers
7.
8.
píçêÉI=pÉí=bå~ÄäÉëI=båíÉê=`ìëíçã=k~ãÉ
Use the following steps to store a memory register, set Enables, and enter a custom
register name:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Press {Description} to display the Keyboard .
11. Enter the desired register description and press {Enter} .
12. Press ENTER on the Keypad . The register is now stored, the Enables are set,
jÉãçêó=píçêÉ=kçíÉë
Please note the following important points regarding memory register storage:
•
•
294
Enter the desired description and press {Enter} .
Note In Store Mode , the description will not appear in the register
table until ENTER is pressed on the Keypad .
Press ENTER on the Keypad . The register is now stored, all Enables are on, and
the custom name has been stored with the register. Above the Keypad , the
selected register number and the custom name appear in the Memory Display ,
adjacent to the prefix " STR: "
Set up the switcher in the exact configuration that you want stored.
On the Keypad , press STORE .
Select the desired modules to include in the register.
Enter the desired register number.
Navigate to the Memory Menu . The selected register will be highlighted in the
table, and the " STORE " banner will be lit red.
Press {Enables} to display the Enables Menu .
On the modules row, press the light blue button for the first module in which you
want to set Enables.
In the "Enables" box, toggle the desired Enables on or off, as required. By default,
they are all on, when you first store a register. Remember that you can also use
the {All On} and {All Off} functions.
Repeat steps 7 and 8 for all remaining modules in which you want to set Enables.
Note In Store Mode , the description will not appear in the register
table until ENTER is pressed on the Keypad .
and the custom name has been stored with the register. Above the Keypad , the
selected register number and the custom name appear in the Memory Display ,
adjacent to the prefix " STR: "
If you are in the midst of a Store procedure, the {Advanced} button is grayed out.
This feature prevents you from locking, unlocking, or deleting registers in the
midst of the procedure.
At any point, prior to pressing ENTER , you can add or remove modules within a
pending Store operation — even if the module buttons were not originally
selected in the Keypad's Module Section .
FSN Series • User's Guide