Barco FSN Series User Manual page 302

8. Updating Software
Software Update Overview
pçÑíï~êÉ=réÇ~íÉ=lîÉêîáÉï
Firmware files for the FSN-1400 and control panel are loaded into the hardware at power-
up. These files are stored in the unit's onboard flash memory. Two different update
procedures can be performed:
•
•
For a "new" software update, following is an overview of the steps required:
1.
2.
3.
4.
5.
6.
7.
8.
e~êÇï~êÉ=oÉèìáêÉãÉåíë
The following hardware items are required for upgrading FSN Series software:
•
•
•
302
Update FSN-1400 and Control Panel — This procedure updates both the control
panel and the FSN-1400. A "new" software update file is required.
Update FSN-1400 only — This procedure updates the FSN-1400 software to
match the control panel software. Use this procedure if the label "
appears in the System Status Table on the System Menu .
Verify your hardware. Refer to the "
Download the appropriate "update" file. Refer to the "
section on page 303.
Transfer the software to a USB thumb drive.
Insert the USB drive into the control panel's top USB port.
In the Navigation Bar , press {System} to display the System Menu .
Press {Software} to display the Software Menu .
To update the control panel, refer to the "
section on page 305.
To update the FSN-1400, refer to the "
page 306.
IBM compatible computer with an available Ethernet port and USB port.
USB thumb drive, minimum 1 GB.
Internet connection.
Hardware Requirements
Downloading Software
Updating Control Panel Software
Updating FSN-1400 Software
FSN Series • User's Guide
Mismatch "
" section below.
"
"
" section on