Barco FSN Series User Manual page 227

•
Button
Test
Mode
Panel
Press any button on the control panel. Results are listed below.
Scan code:
Figure 5-113. Button Test Mode Pop-up
•
Display
Backlight
Test Off
•
Display
Pixel Test
Test Off
FSN Series • User's Guide
Press {Button Test Mode} to display the Button Test Mode Pop-up .
Button Test Mode
Press any button on the panel to display its scan code in the pop-up. Press
{Close} to conclude the test.
Press {Display Backlight} to show the Display Backlight Pop-up , which
enables you to test the backlight of all control panel displays. The following
options are available:
~
Press {All On} to turn all displays on at full brightness.
~
Press {All Off} to turn all displays off.
~
Press {Red On} to turn all bus displays bright red. The transition
displays do not have a red component.
~
Press {Green On} to turn all displays bright green, including the
transition displays.
~
Press {Test Off} to conclude the test, and return all displays to their
previous state, prior to test mode.
Note In this test mode, the {Display Pixel Test} button is grayed
out.
Press {Display Pixel Test} to show the Display Pixel Test Pop-up , which
enables you to test the pixels on all control panel displays. The following options
are available:
~
Press {All Pixels On} to turn all pixels on all displays on.
~
Press {All Pixels Off} to turn all pixels on all displays off.
~
Press {Test Off} to conclude the test, and return all displays to their
previous state, prior to test mode.
Note
In this test mode, the {Display Backlight} button is grayed
out.
5. Menu Orientation
System Menu
Close
227