Barco FSN Series User Manual page 109

lìíéìí=`çååÉÅíáçåë
The figure below illustrates the output connections on the M/E card's I/O panel:
Program Out 2
Program Out 1
M/E 1 Program Out
M/E 1 Preview Out
M/E 1 Clean Out
M/E 2 Program Out
M/E 2 Preview Out
M/E 2 Clean Out
Figure 4-15. Output connections
Use the following steps to connect output signals from the FSN-1400's M/E card.
1.
2.
3.
4.
5.
FSN Series • User's Guide
Preview Out
PVW
Clean Out
CLN
PGM
PVW
CLN
PGM
PVW
CLN
Note All connections use BNC cables. All outputs are SDI (either
SD-SDI or HD-SDI).
The Program Out 1 and Program Out 2 signals are identical. Connect to a
monitor, and to your target destination device as required.
Connect Preview Out to a monitor. This output provides the Program bank's
"lookahead" preview video. In Chapter 7, refer to the
Lookahead Preview" section on page 274 for additional information.
Connect Clean Out to a monitor or the desired destination. This output provides
the system's main clean feed signal. In Chapter 2, refer to the
Output Selection" section on page 46 for details.
Connect M/E 1 Program Out to a monitor or the desired destination. This output
provides M/E 1's program output signal.
Connect M/E 1 Preview Out to a monitor. This output provides the Program
bank's "lookahead" preview video. In Chapter 7, refer to the
Lookahead Preview" section on page 274 for additional information.
PGM
Cut
Fill
1
2
3
4
5
6
4. Installation
Signal Connections
"Understanding
"Clean Feed
"Understanding
109