Table of Contents
Advertisement
7. Operations
Working with Keys
aáêÉÅí=`çåíêçä=hÉóë
In the M/E, the four buttons in the Direct Key Control Group enable you to directly control
the two keyers, without the need to "arm" them in the Next Transition Group . The red
LEDs above the KEY 1 and KEY 2 buttons function in the normal manner.
Use the following steps to perform a direct cut key:
1.
2.
3.
Use the following steps to perform a direct mix key:
1.
2.
3.
Please note the following important points regarding the Direct Control buttons:
•
•
290
Note
Remember that you can use these "direct" functions
regardless of where the T-Bar is currently positioned.
Ensure that the key(s) you wish to transition are properly set up. Refer to the
"
Key Setup
" section for details.
Press CUT KEY 1 to cut Key 1 on or off (depending on its current state).
Press CUT KEY 2 to cut Key 2 on or off (depending on its current state).
Ensure that the key(s) you wish to transition are properly set up. Refer to the
"
Key Setup
" section for details.
Press MIX KEY 1 to mix Key 1 on or off (depending on its current state).
Press MIX KEY 2 to mix Key 2 on or off (depending on its current state).
Unlike the AUTO TRANS button, the two MIX KEY buttons cannot be paused.
Once pressed, the "direct" transition completes fully.
When the T-Bar is positioned between the BG and PST buses (off of a limit),
almost all "direct" transitions are available. In Chapter 3, refer to the "
Transition Section
" heading on page 72 for details.
M/E
FSN Series • User's Guide
Advertisement
Table of Contents
