Barco FSN Series User Manual page 177

•
Set IP
Address
7
4
1
+ / -
Figure 5-72. IP Address keypad (sample)
•
Set
Subnet
Mask
•
Apply
•
Restore
Default
Settings
FSN Series • User's Guide
To change the IP address of a highlighted port, press {Set IP Address} to display
the IP Address Keypad :
Set IP Address
192.168.0.4
Undo
8 9 Clear
5 6 Trim -
2 3 Trim +
0 . Enter
Enter the desired IP address using the decimal point as the separator between the
four "octets," and press {Enter} .
Note You do not have to enter all three digits in a particular octet.
For example, you can enter 4 instead of 004 .
To change the Subnet Mask of a highlighted port, press {Set Subnet Mask} to
display the Subnet Mask Keypad . Enter the desired subnet mask using the
decimal point as the separator between the four "octets," and press {Enter} .
After setting both the IP address and the Subnet Mask , press {Apply} to
complete the procedure.
To return the highlighted port's IP address and Subnet Mask to their factory
default values, press {Restore Default Settings} .
Close
5. Menu Orientation
System Menu
177