Barco FSN Series User Manual page 73

2)
Transition
Figure 3-13. T-Bar and Transition LEDs
3)
BG
Figure 3-14. Next Transition Group
FSN Series • User's Guide
~
Key 2 Source — (directly above the KEY 2 button), indicates the current
source assigned to KEY 2. When you select another source for KEY 2
on the Key Bus, the source label updates.
Note Remember that the SEL button chooses the active key bus,
as indicated by the Key Control LEDs.
~
Current Transition Rate — indicates the auto-transition rate loaded in
the M/E. This rate is used by the AUTO TRAN, MIX KEY 1 and MIX
KEY 2 functions. Use the Transition Menu to change rates. In
Chapter 5, see the
T-Bar and Transition LEDs
The T-Bar provides manual transition control for the layers enabled in the Next
Transition Group. For both manual and automatic transitions, the Transition
LEDs indicate the position of the transition in progress.
LEDs
T-Bar functionality is identical for the M/E and PGM banks. In Chapter 7, refer to
the "Understanding the T-Bar and Transition
complete details.
Next Transition Group
The three buttons in the Next Transition Group indicate which specific
combination of M/E layers is enabled (or "armed") for the next transition. The
state of these buttons affects the M/E's "lookahead" preview output.
KEY KEY
1 2
To use the group, simultaneously press the combination of buttons that you wish
to enable. Any combination can be pressed. Whichever combination you enable
automatic disables those buttons that were not pressed.
For example:
If BG, KEY 1 and KEY 2 are currently lit, pressing BG turns the BG
button on, and turns off the KEY 1 and KEY 2 buttons.
If KEY 1 is currently lit, simultaneously pressing BG and KEY 2
turns the BG and KEY 2 buttons on, and KEY 1 off.
3. Control Panel Orientation
"Transition Menu" section on page 134 for details.
T-Bar
LEDs" section on page 280 for
Control Panel Descriptions
73