Barco FSN Series User Manual page 50

2. FSN-1400 Orientation
Card Descriptions
3)
4)
Table 2-5. UIC connector combinations for selected universal input formats
HD-SDI
SD-SDI
DVI *
CVBS
Y/C
YPbPr **
RGsB
RGBS
RGBHV ***
5)
50
Loaded LED
The Loaded LED indicates the status of all FPGAs on the card. Refer to the
"Card LEDs" section on page 55 for details.
Universal Input 1
Three connectors are provided for Universal Input 1 (1 x HD15, 1 x DVI-I, 1 x
BNC). Using these connectors, different combinations of inputs can be connected
to the FSN-1400, as outlined below, but only one of the three connectors can be
used at a time on the control panel.
Cells with check marks denote the connections required for the indicated format.
Format BNC
* up to 165 MHz
** NTSC, PAL or HD
*** up to 165 MHz (UXGA)
Please note the following important points regarding the UIC:
~
Refer to the "Analog Format Connection
additional information on using the HD-15 connector.
Universal Input 2
Input connections for Universal Input 2 are identical to Universal Input 1. Refer
to the explanation of Universal Input 1 for details.
Note In Appendix A, refer to the
page 313 for details on UIC delay.
Connectors
DVI-I HD-15
Table" section on page 56 for
"Delay Specifications" section on
FSN Series • User's Guide