Barco FSN Series User Manual page 112

4. Installation
Signal Connections
bñíÉêå~ä=aph=fåéìí=`çååÉÅíáçåë
The figure below illustrates external DSK input connections on the M/E card's I/O panel:
PVW
CLN
PGM
PVW
CLN
PGM
PVW
CLN
Figure 4-17. External DSK cut and fill connections
Use the following steps to connect external DSK cut and fill signals to the M/E card.
1.
2.
Please note the following important points:
•
•
•
•
112
PGM
External Cut In
Cut
External Fill In
Fill
1
2
3
4
5
6
Note All connections use BNC cables.
Connect an external cut signal to the Cut connector. This type of signal typically
originates from a character generator's Cut or Key output.
Connect an external fill signal to the Fill connector. This type of signal typically
originates from a character generator's Fill or Video output.
The DSK Cut and Fill inputs must be locked to the same video reference as the
FSN-1400 chassis. SAV (start of active video) must be within +/- 0.5 lines of
frame reference.
The DSK Cut and Fill signals must be set to the system's native resolution.
Use the External DSK Setup Menu to set up the signals. In Chapter 5, refer to
the "External DSK Setup
In Chapter 6, refer to the
step-by-step setup instructions.
Menu" section on page 208 for menu details.
"External DSK Input Setup" section on page 257 for
FSN Series • User's Guide