Barco FSN Series User Manual page 236

5. Menu Orientation
System Menu
•
Soft
Reset
Panel
•
Soft
Reset
FSN-1400
c~Åíçêó=aÉÑ~ìäí=pÉííáåÖë
When you perform a factory reset, the following actions occur:
•
•
•
•
•
•
•
•
•
•
•
•
•
236
Press {Soft Reset Panel} to perform a "soft" reset on the control panel only. All
stored data is preserved. After pressing the button, you will be prompted to
continue or cancel the procedure.
Press {Soft Reset FSN-1400} to perform a "soft" reset on the FSN-1400 only. All
stored data is preserved, but output video may be temporarily interrupted. After
pressing the button, you will be prompted to continue or cancel the procedure.
All switcher buses are set to BLACK , and all transitions are set to MIX .
Output format is set to 1920 x 1080i @ 59.94.
All inputs on NIC #1 are mapped to the control panel, in a 1-1 layout to unshifted
buttons 1 through 8 . Default names are assigned, e.g., N1-1 , N1-2 , etc. No other
inputs are mapped to the panel.
All inputs on subsequent NIC s are not mapped.
All inputs on all UIC s are not mapped.
All Ethernet communications parameters are either returned to factory default
settings or saved — depending on your selection in the Factory Reset Pop-up
Menu .
In the Reference and Output Setup Menu :
~
The reference input is set to External .
~
Output V-lock is set to Off .
In the Input Setup Menu :
~
For native inputs, Sync Mode is set to Auto .
~
For universal inputs, Auto Acquire is set to On .
In the User Preferences Menu , Black on Invalid Video is set to On .
All color background signals (1 through 4) are set to black, as shown on the Color
Background Menu .
In the Transition Menu :
~
All transition Rates are set to 30 frames.
~
All transition curves are set to Linear .
In the Keyer Menus :
~
All key Types are set to Luma .
~
All key Fills are set to Self .
~
External Key is set to Off (in the DSK menu).
In the Wipe Menu :
~
Wipe Direction is set to Normal .
~
Wide Edge is set to Soft .
~
Edge Width is set to 100 .
FSN Series • User's Guide