Barco FSN Series User Manual page 286

7. Operations
Working with Wipes
3.
4.
5.
Please note the following important points regarding mixes:
•
•
tçêâáåÖ=ïáíÜ=táéÉë
A Wipe is a transition in which one video signal is replaced with another signal, using a
selected pattern to determine the edge between the two sources. The transition is always
WIPE
from the source on PGM (or BG ) to the source on PST .
The following topics are discussed in this section:
•
•
•
táéÉ=pÉíìé
Use the following steps to set up the wipe:
1.
2.
3.
j~åì~ä=táéÉ
Use the following steps to perform a manual wipe:
1.
2.
3.
4.
286
On any PST bus, press the button for the desired "next" source. Use the SHIFT
button if required to select a shifted source. Remember that on the PGM bank,
the M/E (re-entry) button can be preset in the same way.
Press MIX .
Press AUTO TRAN .
You can also press ALL TRAN (in the Custom Control Section ) to perform a mix
on all buses simultaneously.
Remember that there are a wide variety of auto-transition combinations available
to you. Refer to the " Automatic Transitions
Prerequisite — Ensure that you are familiar with the Wipe Menu . In
Chapter 5, refer to the "
Wipe Setup
Manual Wipe
Automatic Wipe
Navigate to the Wipe Menu using one of the following two methods:
~
Press and hold WIPE in the bank in which you want to perform the wipe.
Remember that you can change banks using the {Bank} button.
~
In the Menu Bar , press {Page} to jump to page 1, then press {Wipes} .
Select the desired wipe pattern, direction, edge type, edge width, and edge color
(if Hard Edge is selected).
Set the desired auto transition rate and curve.
In the Next Transition Group , press BG .
On any PST bus, press the button for the desired "next" source. Use the SHIFT
button if required to select a shifted source. Remember that on the PGM bank,
the M/E (re-entry) button can be preset in the same way.
Press WIPE .
Use the T-Bar to perform the manual wipe.
" section on page 280 for details.
Wipe Menu " section on page 137.
FSN Series • User's Guide