Barco FSN Series User Manual page 258

6. System Setup
Button Mapping
_ìííçå=j~ééáåÖ
FSN Series system setup: Step 12
This procedure enables you to map individual inputs to the panel. The menu also enables
12
you to map linear key cut and fill signals, test patterns and color background signals.
Use the following steps to map buttons:
1.
2.
3.
4.
5.
6.
7.
Please note the following important points:
•
258
Prerequisite — Ensure that you are familiar with the Map Buttons Menu . In
Chapter 5, refer to the "
In the Menu Bar , press {System} to access the System Menu .
Press {Map Buttons} to display the Map Buttons Menu .
Use the {Panel Button} control to select the button you wish to map. Press
{SHIFT} to map the button's shifted position. The table changes accordingly.
To map an input (source) or a linear key "cut" signal to the selected button, press
{Map Source/Cut} . The Map Buttons Keypad appears.
~
To map a source, press {Source} to display sources only. Select the
desired source and press {Map} .
~
To map a test pattern, press {Test Patterns} to display internal test
patterns only. Select the desired test pattern and press {Map} .
~
To map a color background signal, press {Color BG} to display the four
available internal color background signals. Select the desired signal
and press {Map} .
To map a linear key "fill" signal to the selected button, press {Map Linear Key
Fill} . The Map Buttons Keypad appears.
~
To map a source, press {Source} to display sources only. Select the
desired source and press {Map} .
~
To map a test pattern, press {Test Patterns} to display internal test
patterns only. Select the desired test pattern and press {Map} .
~
To map a color background signal, press {Color BG} to display the four
available internal color background signals. Select the desired signal
and press {Map} .
To clear a source from the panel, select the button you wish to clear, then press
{Clear Source/Cut} .
To clear a linear key fill source from the panel, select the button you wish to clear,
then press {Clear Linear Key Fill} .
When a source is mapped to a button on which another source is already
mapped, the previous source is overwritten and un-assigned. On the Input
Menu , the previous source's BNC turns yellow, but its name remains in the table.
Map Buttons Menu ," on page 210.
FSN Series • User's Guide