External Dsk Setup Menu; External Dsk Table; Dsk Fill Setup - Barco FSN Series User Manual

5. Menu Orientation
System Menu
bñíÉêå~ä=aph=pÉíìé=jÉåì
From the System Menu , press {External DSK Setup} to display the External DSK Setup
Menu , which enables you to set up the DSK Cut and Fill inputs on the M/E Card . These
two inputs are only used on the DSK when {External Key} is enabled.
The figure below illustrates a sample menu, with the DSK Fill connector selected.
Figure 5-97.
The External DSK Setup Menu is divided in half:
•
•
To set up an external DSK input, press the desired connector in the Rear I/O View . In the
External DSK Table , the selected input is automatically highlighted.
The following topics are discussed in this section:
•
•
208
External DSK Setup Menu, DSK Fill selected (sample)
The left side of the Palette shows the Rear I/O View , in which only the two DSK
input connectors are active. All other output connectors are grayed out.
The right side of the Palette shows the External DSK Table , which provides
information about each input.
Note The DSK Cut input can not be adjusted. To prevent error
messages, if the input is not used, turn off error reporting.

External DSK Table

DSK Fill Setup

FSN Series • User's Guide