Barco FSN Series User Manual page 295

•
oÉÅ~ääáåÖ=jÉãçêó=oÉÖáëíÉêë
When you recall a memory register, you are recalling all (or part) of the stored register's
contents back to the switcher.
Recalling a memory register and bypassing the Enables is an easy equation. This method
recalls the entire contents of the selected module(s).
•
Recalling a memory register and adjusting Enables is also an easy equation. This method
recalls partial contents of the selected module(s).
•
The following topics are discussed in this section:
•
•
•
oÉÅ~ääI=_óé~ëë=bå~ÄäÉë
Use the following steps to recall a memory register and bypass Enables:
1.
2.
3.
FSN Series • User's Guide
For example:
You originally pressed the M/E 1 module button only, and you now
wish to add one or two Aux routes to the register.
You originally pressed the M/E 1 and PGM modules, but you now
decide you want to remove the M/E 1 module from the register.
To add modules (prior to pressing ENTER ):
~
In the Enables Menu , press the light blue button for module you wish to
add (even if it was not originally selected). All Enables will be off initially,
but as soon as you toggle any Enable on, the associated module button
in the Keypad lights. You can also press {All On} .
~
At any time in the pending Store procedure, simply light the desired
module button in the Keypad . This action turn all Enables in the
selected module on, and then you can "set" them in the normal way.
To remove modules (prior to pressing ENTER ):
~
In the Enables Menu , press the light blue button for module you wish to
remove, and press {All Off} . The associated module button in the
Keypad turns off.
~
At any time in the pending Store procedure, simply turn off the desired
module button in the Keypad . This action turn all Enables in the
selected module off — effectively removing the module from the register.
Remember that once ENTER is pressed, the module's contents are set — and
you can no longer add to the register. On recall, however, you can elect to recall
all of the register's contents, or part of the contents by using your Enables.
RECALL , [select register #] , ENTER
RECALL , [select modules] , [adjust Enables] , ENTER
Recall, Bypass Enables
Recall, Adjust Enables
Memory Recall Notes
On the Keypad , press RECALL .
Enter the desired register number. Note that the module buttons will light for the
exact modules contained in the register.
Press ENTER . The entire memory register is now recalled to the panel.
7. Operations
Working with Memory Registers
295