Barco FSN Series User Manual page 299

tçêâáåÖ=ïáíÜ=^ìñ=_ìëÉë
The switcher's Aux Section enables you to route input sources and selected outputs to
various "destinations."
Use the following steps to assign sources to Aux bus outputs:
1.
2.
3.
pÉäÉÅíáåÖ=`äÉ~å=cÉÉÇ=lìíéìíë
The Clean Feed Setup Menu enables you to set clean feed outputs, and the source for the
ASSIGN button (in the control panel's Aux Section ).
Use the following steps to select clean feed outputs and the ASSIGN button source:
1.
2.
3.
FSN Series • User's Guide
Prerequisite — Ensure that you are familiar with the Aux Section . In
Chapter 3, refer to the "
On the Aux Bus Row , select the Aux output that you want to assign.
On the Aux Source Row , select one of the following:
~
Select a new source.
~
Select Black .
~
Select an output (e.g., M/E 1 , PGM ).
~
Select a clean feed source by pressing ASSIGN , and choosing the
desired source from the Clean Feed Setup Menu . Refer to the
" Selecting Clean Feed Outputs
Note Remember that only one clean feed source can be mapped to
the ASSIGN button for all Aux buses. For example, you
cannot map " Pre KEY 1 " to Aux 1, and " Pre KEY 2 " to Aux 2.
Repeat the procedure from step 1 to make additional assignments.
Prerequisites
~
Ensure that you are familiar with the Aux Section . In Chapter 3, refer to
the " Aux Section
~
Ensure that you are familiar with the Clean Feed Setup Menu . In
Chapter 5, refer to the "
Navigate to the System Menu :
~
In the Menu Bar , press {Page} to display page 2 (if required). Then,
press the {System} button.
Press {Clean Feed Setup} to display the Clean Feed Setup Menu .
To set clean feed outputs:
~
Press the blue {Clean Feed Outputs} button. The Palette changes to
the Clean Feed Outputs flowchart.
~
Select the desired clean feed point for each output.
Aux Section " heading on page 78 for details.
" section below for details.
" heading on page 78 for details.
Clean Feed Setup Menu
7. Operations
Working with Aux Buses
" section on page 184.
299