Barco FSN Series User Manual page 181

•
SDI
Output
Timing
•
Output
V-Lock
Info
Note
Please note the following important information:
When Output V-Lock is on, H and V offsets can be set
anywhere relative to the external video reference input. All
native inputs are forced to Frame Sync mode, and one
frame of delay will be incurred on all native inputs. On the
Input Setup Menu, the Sync Mode button is grayed out.
When Output V-Lock is off, you can not set H and V
offsets. On the Input Setup Menu, the Sync Mode button
is active.
Figure 5-76. Output V-Lock Information Pop-up
FSN Series • User's Guide
Important
When {Output V-Lock} is
and DSK Fill inputs on screen will change.
•
•
~
Off — In this mode, you can not set H and V offsets, and the {Sync
Mode} button is active on the Input Setup Menu .
Note When {Output V-Lock} is turned
all inputs return to Auto Mode on the Input Setup Menu .
Important When {Output V-Lock} is
amount of video delay through the switcher. The DSK Cut
and DSK Fill inputs must be within ± 0.5 line of video
reference.
When {Output V-Lock} is
offsets, anywhere relative to video reference. Two value buttons appear:
~
Press {SDI H Offset} or use the adjacent Knob to set the desired
amount of horizontal offset (in pixels) from video reference.
~
Press {SDI V Offset} or use the adjacent Knob to set the desired
amount of vertical offset (in lines) from video reference.
Press the {Output V-Lock Info} button to display a pop-up with important
information regarding the Output V-Lock mode. This button only appears when
the {Reference Input} button is set to External .
Output V-Lock Information
On , the position of the DSK Cut
If the user preference " Black on Invalid Video " is
turned on, the DSK turns off — because of the change
in output timing.
If the user preference " Black on Invalid Video " is off,
the DSK will be visible — but in a shifted position. In
this condition, the video position can be adjusted by
changing the output timing of the DSK source itself.
Off , this mode provides the least
On , press {SDI Output Timing} to set SDI H and V
Close
5. Menu Orientation
System Menu
Off , after having been On
181
,