Barco FSN Series User Manual page 288

7. Operations
Working with Keys
hÉó=pÉíìé
Use the following steps to set up the key:
1.
2.
3.
4.
5.
j~åì~ä=jáñ=hÉó
Use the following steps to perform a manual mix key:
1.
2.
3.
288
Navigate to the Keyer Menu using one of the following two methods:
~
Arm the keyer that you wish to transition ( KEY 1 , KEY 2 or DSK ). Then,
press and hold that specific Key button. This action places the key on
the PVW output for the selected bank.
~
In the Menu Bar , press {Page} to jump to page 1 (if required), then press
{Keys} . Remember that you can change keyers with the {Keyer} button.
Select the desired key "cut" source:
~
To set up Key 1 on the M/E, press SEL to switch the key bus to KEY 1 .
Select the desired source on the bus.
~
To set up Key 2 on the M/E, press SEL to switch the key bus to KEY 2 .
Select the desired source on the bus.
~
To set up the DSK , press and hold DSK to change the PST bus to the
phantom key bus. Select the desired source on the bus, then release
the DSK button. Remember that the M/E can also be a key source.
On the Keyer Menu :
a. Select the desired key type: luma or linear.
b. Select the desired key fill: self, matte, preset or split.
• If a matte fill is selected, set the desired matte color.
• If a preset fill is selected, select the desired fill source on the
bank's PST bus.
• If split key is selected, select the split cut and fill sources.
c. Set the key's clip, gain and opacity.
Set the desired auto transition rate and curve.
Repeat for all other keys that you wish to transition.
Ensure that the key(s) you wish to transition are properly set up. Refer to the
" Key Setup " section for details.
In the Next Transition Group , select the layers that you wish to transition:
~
On the M/E, enable BG , KEY 1 and/or KEY 2 as desired.
~
On the PGM bank, enable BG and/or DSK as desired.
Use the T-Bar to perform the manual mix key. The selected key(s) will transition
up or down, depending on their current state.
FSN Series • User's Guide