Table of Contents
Advertisement
qê~åëáíáçå=jÉåì=^ÅÅÉëë
There are two ways to access the Transition Menu :
•
•
qê~åëáíáçå=o~íÉ=^ÇàìëíãÉåí
Transition rates can be adjusted from 1 to 999 frames, in 1 frame increments. There are
two ways to adjust rates individually:
•
M/E 1
30
•
You can also enter or trim all transition rates simultaneously:
•
All
Set/Trim
•
FSN Series • User's Guide
In the Menu Bar , press {Page} to display page 1 (if required). Then, press the
{Trans} button.
Press and hold any MIX button on the control panel (e.g., MIX in the M/E 1 bank
or the PGM bank).
Turn the Knob adjacent to the any value button to adjust the auto transition rate
(in frames) for that specific location ( M/E 1 , PGM or FTB ).
~
The value on the button changes as you adjust, and the associated
Transition Display (on the panel) updates.
~
Changes in rates take effect immediately.
To "key in" an auto transition rate, press any value button to display the Keypad
for that specific location. Enter a new rate (in frames) and press {Enter} , or trim
the current rate using {Trim -} or {Trim +} .
To set all rates to the same value, press {All/Set Trim} . All value buttons light.
Next, press any value button to display the keypad.
~
To set all rates to the value in the keypad's register, press {Enter} .
~
To set all rates to a new value, enter the new value and press {Enter} .
To trim all rates simultaneously as offsets to their current values, press {All/Set
Trim} . All value buttons light. There are two ways to trim the value:
~
Turn any Knob to increment or decrement all rates.
~
Press any value button to display the keypad. Enter the desired "trim"
value and press {Trim +} or {Trim -} as desired.
5. Menu Orientation
Transition Menu
135
Advertisement
Table of Contents
