Barco FSN Series User Manual page 110

4. Installation
Signal Connections
6.
Please note the following important points:
•
•
110
Connect M/E 1 Clean Out to a monitor or the desired destination. This output
provides M/E 1's clean feed signal. In Chapter 2, refer to the
Selection" section on page 46 for details.
Note M/E 2 outputs are used in conjunction with the FSN-250
control panel, and are not currently implemented.
All outputs run at the system's selected native output resolution.
In Chapter 6, refer to the "Reference Video and Output
page 248 for instructions on setting the native resolution.
"Clean Feed Output
Setup" section on
FSN Series • User's Guide