Barco FSN Series User Manual page 285

5.
tçêâáåÖ=ïáíÜ=jáñÉë
A Mix (or "dissolve") is a transition in which one video signal fades out as another fades in.
The transition is always from the source on PGM (or BG ) to the source on PST .
MIX
The following topics are discussed in this section:
•
•
j~åì~ä=jáñ
Use the following steps to perform a manual mix:
1.
2.
3.
4.
^ìíçã~íáÅ=jáñ
Use the following steps to perform an automatic mix:
1.
2.
FSN Series • User's Guide
• Press any value button to display the Keypad . Enter the
desired "trim" value and press {Trim +} or {Trim -} as desired.
Note The M/E 1 transition rate applies to the buttons in the Direct
Key Control Group ( MIX KEY 1 and MIX KEY 2 ).
Transition curves are applied when you press AUTO TRAN in a selected bank, or
the FTB button. To select transition curves:
~
For M/E 1 curve, press the {Linear} , {S Curve} , {Exponential} , or
{Logarithmic} button in the row adjacent to the M/E 1 button.
~
For the PGM bank curve, press the {Linear} , {S Curve} , {Exponential} ,
or {Logarithmic} button in the row adjacent to the PGM button.
~
For the FTB curve, press the {Linear} , {S Curve} , {Exponential} , or
{Logarithmic} button in the row adjacent to the FTB button.
Note Transition curves also apply to the buttons in the Direct Key
Control Group ( MIX KEY 1 and MIX KEY 2 ).
Manual Mix
Automatic Mix
In the Next Transition Group , press BG .
On any PST bus, press the button for the desired "next" source. Use the SHIFT
button if required to select a shifted source. Remember that on the PGM bank,
the M/E (re-entry) button can be preset in the same way.
Press MIX .
Use the T-Bar to perform the manual mix.
Set the desired auto transition rate and curve. Refer to the "
Rates and Curves " section on page 284 for details.
In the Next Transition Group , press BG .
7. Operations
Working with Mixes
Setting Transition
285