Barco FSN Series User Manual page 251

`äÉ~å=cÉÉÇ=pÉíìé
FSN Series system setup: Step 8
In this procedure, you can set clean feed outputs, and select a source for the ASSIGN
8
button (in the control panel's Aux Section ).
Use the following steps to set clean feed outputs:
1.
2.
3.
4.
5.
Use the following steps to select the clean feed source that is mapped to the ASSIGN
button in the control panel's Aux Section :
6.
7.
Please note:
•
•
FSN Series • User's Guide
Prerequisite — Ensure that you are familiar with the Clean Feed Setup
Menu . In Chapter 5, refer to the "
page 184.
In the Menu Bar , press {System} to access the System Menu .
Press {Clean Feed Setup} to display the Clean Feed Setup Menu .
Press {Clean Feed Outputs} to display the Clean Feed Outputs Chart .
On the chart, select the desired clean feed point for M/E 1's clean feed output:
~
Press {M/E 1 Clean 1} to select the point prior to Keyer 1.
~
Press {M/E 1 Clean 2} to select the point prior to Keyer 2.
~
Press {M/E 1 Out} to select the point after Keyer 2.
Select the desired clean feed point for the PGM bank's clean feed output:
~
Press {PGM Clean} to select the point prior to the DSK.
~
Press {PGM Out} to select the point after the DSK.
Press {Assign Button} to display the Assign Button Chart .
Select one of three mutually exclusive clean feed points for the button:
~
Press {M/E 1 Clean 1} to select the point prior to Keyer 1.
~
Press {M/E 1 Clean 2} to select the point prior to Keyer 2.
~
Press {PGM Clean} to select the point prior to the DSK.
The clean feed selection is global for all Aux routes. If you change the mapping
for one route, it changes for all routes.
To quickly display the Assign Button Tab , press and hold the ASSIGN button.
6. System Setup
Clean Feed Setup
Clean Feed Setup Menu " section on
251