Barco FSN Series User Manual page 305

réÇ~íáåÖ=`çåíêçä=m~åÉä=pçÑíï~êÉ
Use the following steps to update control panel software.
1.
2.
3.
4.
5.
6.
7.
Update
8.
Software
9.
10. Unplug the USB drive.
11. When the pop-up clears, you can continue with the "
FSN Series • User's Guide
Ensure that the correct version of software has been properly downloaded from
the website or the FTP site. If not, refer to the "
on page 303 for instructions.
On your PC or laptop, transfer the software to a USB thumb drive.
Important Place the FSN software file at the drive's root. Ensure that
only one FSN software file is present at the root.
Insert the USB drive into the control panel's top USB port.
In the Navigation Bar , press {System} to display the System Menu .
Press {Software} to display the Software Menu .
Note the current software version in the Status Table .
Press {Update Software} .
In the confirmation pop-up, press {Yes} . A pop-up alerts you that the update is in
progress.
When the file has been fully transferred, press {Restart} . A pop-up alerts you that
the system is re-initializing.
Software " section on page 306.
8. Updating Software
Updating Control Panel Software
Downloading Software " section
Updating FSN-1400
305