Barco FSN Series User Manual page 284

7. Operations
Setting Transition Rates and Curves
4.
pÉííáåÖ=qê~åëáíáçå=o~íÉë=~åÇ=`ìêîÉë
The Transition Menu enables you to change auto transition rates and adjust transition
"curves" throughout the switcher.
Use the following steps to set transition rates and curves:
1.
MIX
2.
3.
4.
284
Press CUT again to return to the previous source, or select a new source on PST
and repeat the procedure.
Note You can also press ALL CUT (in the Custom Control
Section ) to perform a cut on all buses simultaneously.
Prerequisite — Ensure that you are familiar with the Transition Menu . In
Chapter 5, refer to the "
Navigate to the Transition Menu using one of the following two methods:
~
Press and hold any MIX button.
~
In the Menu Bar , press {Page} to jump to page 1 (if required), then press
{Trans} .
To adjust transition rates with the knobs:
~
Turn the knob adjacent to the M/E 1 button to adjust M/E 1's transition
rate. The range is 1 to 999 frames.
~
Turn the knob adjacent to the PGM button to adjust the PGM bank's
transition rate.
~
Turn the knob adjacent to the FTB button to adjust the FTB transition
rate.
To adjust transition rates with the Keypad :
~
Press the M/E 1 button to display the Keypad . Enter or trim the
transition rate for M/E 1, then press {Enter} to accept.
~
Press the PGM button to display the Keypad . Enter or trim the transition
rate for the PGM bank, then press {Enter} to accept.
~
Press the FTB button to display the Keypad . Enter or trim the transition
rate for the FTB, then press {Enter} to accept.
To adjust all transition rates simultaneously, press {All/Set Trim} .
~
To "set" a new rate, press any value button to display the Keypad .
• To set all rates to the current value in the register, press
{Enter} .
• To set all rates to a new value, enter the value and press
{Enter} .
~
To trim all rates simultaneously as offsets to their current values:
• Turn any Knob to increment or decrement all rates.
Transition Menu " section on page 134.
FSN Series • User's Guide