Barco FSN Series User Manual page 63

mdj=_~åâ
The PGM Bank is the switcher's top video layer. The bank includes two physical buses
(PGM and PST), and one "phantom" KEY bus. Together, these buses are the switcher's
primary location where you cut your program and transition to M/E setups. Please note:
•
•
•
•
•
The figure below illustrates the PGM Bank on the FSN-150.
PGM
CAM1
1
GFX1
2
P
G BLACK
M
3
P
S BLACK
T
DSK Assign
Figure 3-4. PGM Bank, FSN-150
1)
2)
3)
Following are descriptions of each section:
1)
FSN Series • User's Guide
The PGM Bank has an associated PGM Transition Section to its right, where
effects and transitions (such as mixes, wipes and keys) are set up using the
sources selected in the buses.
Using the Memory/Transition Section, you can store all or part of the PGM bank.
The PGM Bank provides tally indications similar to the M/E. In Chapter 7, refer to
the "Understanding Tally" section on page 270 for details.
The buses in the PGM Bank operate in "flip-flop" mode. In Chapter 7, refer to the
"Understanding Flip-flop
Button color has important significance in the PGM Bank. In Chapter 7, refer to
the "Understanding Button
CAM2 CAM3 VTR1 VTR2 DVD1
GFX2 VTR3 DVD2
Programmable Displays
Program Bus
Preset and Phantom Key Bus
Programmable Displays
Above each source button on the PGM Bus, a Programmable Display shows
the source names that are assigned during setup (e.g., CAM1, VTR2, etc.). The
labels are dynamic — if the source is mapped to another button, the label follows.
Note In the Programmable Displays, the top row is the unshifted
source, the bottom row is the shifted source.
If an error occurs to either the shifted or unshifted input, the Programmable
Display turns red. In Chapter 7, refer to the
section on page 271 for full details.
3. Control Panel Orientation
Mode" section on page 269 for details.
Color" section on page 267 for details.
PC1 PC2 STL1 STL2
PC3 COL1 COL2
4) Re-entry Buttons
5) SHIFT Buttons
"Understanding Error
Control Panel Descriptions
4
SHIFT M/E
SHIFT M/E
5
Messages"
63