Barco FSN Series User Manual page 69

7)
FTB
FSN Series • User's Guide
BG + WIPE enabled — press AUTO TRAN to wipe from PGM to
PST.
DSK + MIX enabled — press AUTO TRAN to mix the DSK on or off.
BG + DSK + MIX enabled — press AUTO TRAN to mix from PGM
to PST, and simultaneously mix the DSK on or off.
Press AUTO TRAN during the transition interval to pause the transition. The
Transition LEDS indicate the point at which the transition is paused. Press
AUTO TRAN again to continue in the same direction. You can pause and
continue repeatedly.
Note Use the Transition Menu to change transition rates and to
select transition curves. Remember that the bank's transition
rate appears in the Transition Display. In Chapter 5, refer to
the "Transition
Note You can use AUTO TRAN and the T-Bar together. For
example, you can start a transition manually, and continue it
automatically. In Chapter 7, refer to the
Mixes" section on page 285 for full details.
FTB
The FTB (Fade to Black) button enables you to transition the switcher's Program
output to black. Please note:
~
When pressed, the switcher fades to black, including the DSK. Once in
black, the FTB button blinks.
~
While in black, the M/E bank is fully functional. Any source can be preset
on any bus, and any memory register can be recalled — but the setups
will not contribute to the switcher's Program output. However, individual
M/E outputs are still functional (e.g., M/E 1 Out).
~
When FTB is pressed again, the switcher fades up from black to the
current setup. If the DSK is enabled, it remains enabled.
~
Use the Transition Menu to change the FTB transition rate. The current
transition rate appears in the Transition Display. In Chapter 5, refer to
the "Transition Menu" section on page 134 for details
3. Control Panel Orientation
Control Panel Descriptions
Menu" section on page 134 for details.
"Working with
69