Panasonic GA-ML Series Manual page 49

Parameter
Number of LLDP Error
Retries
(1-10)
Average Traffics
(1-60)
Traffic Interval
(1-60)
Number of Retries
during Traffic Errors
(1-10)
Global Status of PoE
Auto Reboot
Subject of SMTP
Mails regarding PoE
Auto-reboot
Contents of SMTP
Emails regarding PoE
Auto-reboot
From Port / To Port
Ping IP Address
LLDP Monitor
Condition of
Determining Traffics
Unit of Threshold
regarding Traffics
Threshold for Traffics This parameter configures the threshold of traffics.
Condition of
Determination
Sending Emails
SNMP Traps
PoE OFF/ON
This parameter configures the number of retrials during
errors as for monitoring the auto-reboot LLDP, which is
used for the PoE auto-reboot (factory default settings:
3).
This parameter configures the interval for calculating
the average value of traffics, which exist in a device
(factory default settings: 5).
This parameter configures the interval for monitoring
traffics with seconds, as a unit (factory default settings:
5).
This parameter configures the number of retrials during
traffic errors (factory dsefault Settings: 3).
This parameter enables or disables the global settings
for PoE auto-reboot.
This parameter sets a subject when you notify via
emails, which are done (or sent) by an SMTP of PoE
auto-reboot.
This parameter configures the content when notifying
via emails, which are done (or sent) by an SMTP of PoE
auto-reboot.
Choose the range of the port-number.
This parameter configures an IP address of the Ping,
which is used for the PoE auto-reboot.
This parameter enables or disables the settings for
monitoring LLDP of PoE auto-reboot.
This parameter configures the determination regarding
an abnormality of PoE terminal because of the
communication-fee. The options available are None,
Below and Over.
This parameter configures the unit of the traffic-
threshold.
This parameter configures the condition of determining
an abnormality of the monitoring-methods (e.g. Ping,
LLDP and traffics). The options available are Or and
And.
This parameter enables or disables the settings for
sending e-mails regarding the PoE auto-reboot.
This parameter enables or disables the settings for
SNMP traps regarding the PoE auto-reboot.
This parameter enables or disables the execution of PoE
OFF/ON when your switch determines an abnormality
of the PoE auto-reboot.
3.7.6 PoE Auto-Reboot Settings
Overview
3 System
47