Arp Inspection Port Settings - Panasonic GA-ML Series Manual

9.7.1.2.3

ARP Inspection Port Settings

Use the following window to implement the settings on the ARP
inspection port settings and display its settings.
Choose Security > SAVI > IPv4 > Dynamic ARP Inspection > ARP
Inspection Port Settings to display the following window.
You can configure the following parameters.
Parameter
From Port/ To Port
Rate Limit
Burst Interval
Trust State
Click Apply to reflect the change.
Click Default Configuration to set the trust state to the default settings.
Figure 9-49 ARP Inspection Port Settings
Choose the port you use.
Enter the value of rate limit. The range is from 1 to 150
(packets), per second.
Enter the value of a burst-interval. The range is from 1
to 15. If you set None to on, the option becomes
disabled.
This parameter enables or disables the trust state.
9.7.1.2.3 ARP Inspection Port Settings
Overview
9 Security
339