Panasonic GA-ML Series Manual page 227

In the section of Police Action, you can configure the following
parameters.
Parameter
None
Specify
CIR
Confirm Burst
PIR
Peak Burst
Conform Traffic
Action
If you choose this option, a policer is not configured in
this entry.
If you choose this option, the following policer
configuration is applied in this entry.
Enter the value of CIR (Committed Information Rate).
This is the first token bucket for two-rate metering.
The range is from 0 to 10,000,000 (Kbps).
Enter the value of a burst confirmation. This is the size
of the first token bucket. The range is from 0 to 16,384
(kilo-bytes).
Enter the value of PIR (Peak Information Rate). This is
the second token bucket for two-rate metering.
The range is from 0 to 10,000,000.
Enter the value of the peak burst. This is the size of the
second token bucket. The range is from 0 to 16,384
(kilo-bytes).
Choose the conform traffic action to execute. This
action is performed on green colored packets. The
options available are as follows.
• Drop - This option allows you to drop the packets.
• Set-DSCP-Transmit - This option allows you to
configure and transmit the value of new DSCP to
packets. Enter the DSCP value in the entry field
displayed.
• Set-1P-Transmit - This option allows you to
configure and transmit the value of new IEEE 802.1p
to packets. Enter the IEEE 802.1p value in the entry
field displayed.
• Transmission - This option allows you to transmit
packets without changing them.
• DSCP-1P Configuration - This option allows you to
configure and transmit the values of a new DSCP
and IEEE 802.1p to packets. Enter the values in the
entry field displayed.
7 QoS (Quality of Service)
7.2.8 Policy Map
Overview
225