Panasonic GA-ML Series Manual page 238

You can configure the following parameters.
Parameter
Sequence Number
Protocol Type
Source
Destination
Enter the ACL rule number. The range is from 1 to
65,535. If you choose Auto Allocation, the ACL rule
number regarding this entry is automatically generated.
Choose the protocol type option. The options available
are TCP, UDP, ICMP, EIGRP (88), ESP (50), GRE (47),
IGMP (2), OSPF (89), PIM (103), VRRP (112), IP-in-IP
(94), PCP (108), Protocol ID and None.
• Value - You can enter the protocol ID, manually. The
range is from 0 to 255.
• Mask - After choosing the Protocol ID option, enter
the value of the protocol mask, manually. The range
is from 0x0 to 0xFF.
• Fragment - If you choose this option, the packet
fragment filtering is included.
Choose and enter the source information. The options
available are as follows.
• Optional - Evaluates optional source traffics
according to this rule condition.
• Host - Uses and enters an IP address of source host.
• IP - Use the bit-map of Wildcard, and then use and
enter a group of the source IP address. The bit
corresponding to the bit-value of 1 is ignored, but
the bit corresponding to the bit-value of 0 is
checked.
Choose and enter the destination information. The
options available are as follows.
• Optional - Evaluates the optional destination traffic
according to this rule condition.
• Host - Uses and enters an IP address of a destination
host.
• IP - Use the bit-map of Wildcard, and then use and
enter a group of the destination IP address. The bit
corresponding to the bit value of 1 is ignored, but
the bit corresponding to the bit value of 0 is checked.
8 ACL (Access Control List)
8.1.2 IPv4
Overview
236