Panasonic GA-ML Series Manual page 215

You can configure the following parameters.
Parameter
None
Specify
ACL Name
CoS List
DSCP List
Precedence List
Protocol Name
VID List
Click Apply to check the content changed.
Click Back to return to the previous window.
If you choose this option, nothing is matched with this
class map.
If you choose this option, one of the following
parameters is matched with this class map.
Choose and enter the name of the access list to be
matched with this class map. The number of characters
for the name can be up to 32.
Choose and enter the value of CoS list to be matched
with this class map. The range is from 0 to 7.
Choose and enter the value of DSCP list to be matched
with this class map. The range is from 0 to 63. If you set
IPv4 to on, only IPv4 packets are matched. If not
specified, the reconciliation (or cross-check) targets for
both IPv4 and IPv6 packets.
Choose and enter the value of a precedence list that
matches with this class map. The range is from 0 to 7.
If you set the IPv4 option to on, IPv4 packets are
matched, only. If not specified, the reconciliation
targets for both IPv4 and IPv6 packets. In the case of
IPv6 packets, the top three-bits of traffic class for the
IPv6 header can be the precedence. The range is from 0
to 7.
Choose a protocol name to match it with this class map.
The options available are ARP, BGP, DHCP, DNS, EGP,
FTP, IPv4, IPv6, NetBIOS, NFS, NTP, OSPF, PPPOE,
RIP, RTSP, SSH, Telnet and TFTP.
Choose and enter a VLAN ID to match it with the class
map. You can enter its consecutive VLAN IDs by
delimiting with a comma or enter the range of the
VLAN IDs by delimiting with a hyphen. The range is
from 1 to 4,094.
7 QoS (Quality of Service)
7.2.6 Class Map
Overview
213