Panasonic GA-ML Series Manual page 192

In the section of IPv6 Interface Settings, you can configure the following
parameters.
Parameter
IPv6 MTU
IPv6 State
Click Back to return to the previous window.
Click Apply to reflect the change.
In the section of the Static IPv6 Address Settings, you can configure the
following parameter.
Parameter
IPv6 Address
Click Apply to reflect the change.
Click the Interface IPav6 Address tab tao display the following window.
Figure 6-11 IPv6 Interface (Show Detail and Interface IPv6 Address）
Click Delete to delete the entry specified.
If two or more pages exist, enter the page numbers. Then click Go to
move to a specific page.
Enter the value of IPv6 MTU. The range is from 1,280 to
65,534 (bytes). By default, the value is set to 1,500
(bytes). Use this parameter to configure MTU, which
can be advertised by a router advertise (RA) message.
This parameter enables or disables the global state for
IPv6 Interface.
Enter an IPv6 address of this IPv6 Interface.
• If you choose Extended Unique Identifier 64-bit (EUI-
64), you can configure the IPv6 address on an
interface that uses EUI-64 Interface ID.
• If you choose Link Local, you can configure its link
local address of the IPv6 interface.
6 L3 Features
6.4.2 IPv6 Interface
Overview
Overview
190