Panasonic GA-ML Series Manual page 239

Parameter
Source Port
Destination Port
Specify ICMP
Message Type
ICMP Message Type
Choose and enter the value of the source port.
The options available are as follows.
• = - ACL uses the port-number specified, only.
• > - ACL uses all the ports, which are greater than the
port-number specified.
• < - ACL uses all the ports, which are smaller than the
port-number specified.
• ≠ - ACL uses all the ports except the port-number
specified.
• Range - ACL uses the port, which is specified within
the range.
• Mask - ACL uses the port within the range of the
mask specified. Enter the value of a port-mask in the
entry field displayed. The range is from 0x0 to
0xFFFF.
This parameter is available when you select TCP or UDP
as the protocol type.
Choose and enter the value of the destination port.
The options available are as follows.
• = - ACL uses the port-number specified, only.
• > - ACL uses all the ports, which are greater than the
port-number specified.
• < - ACL uses all the ports, which are smaller than the
port-number specified.
• ≠ -ACL uses all the ports except the port-number
specified.
• Range - ACL uses the port, which is specified within
the range.
• Mask - ACL uses the port within the range of the
mask specified. Enter the value of a port-mask in the
entry field displayed. The range is from 0x0 to
0xFFFF.
This parameter is available when you select TCP or UDP
as the protocol type.
Choose the ICMP Message Type you use. This
parameter is available when you select ICMP as the
protocol type.
If you do not choose the Specify ICMP Message type,
enter the numerical value of the ICMP Message Type
you use. The range is from 0 to 255. If you choose the
ICMP Message Type, the numerical value of the
message type is automatically entered. This parameter
is available when you select ICMP as the protocol type.
8 ACL (Access Control List)
8.1.2 IPv4
Overview
237